50,1; 50,1; -2370 -721 Collapsed -2348 -1019 ConnectedOnly -563 -790 ConnectedOnly -2227 -1433 ConnectedOnly -1984 -1530 ConnectedOnly -2397 -1318 ConnectedOnly -2183 -1303 ConnectedOnly -1756 -1393 ConnectedOnly -1351 -1513 ConnectedOnly -1626 -1369 Collapsed -1123 -1388 ConnectedOnly -2393 -1112 ConnectedOnly -1421 -1084 Collapsed -1326 -1364 ConnectedOnly move-up a few douzen times for larger compounds, you can move it up once (per port if several), copy / paste the corresponding code(s) in the script editor, and replace "-1" with say "-10", and click Run a few times until it's in the approximate range, Then only a few up or down moves are necessary to reach the intended position. Ports will show-up in the "Default" tab in the UI, so you may want to copy / paste the intended tab and group names from other ports to a notepad pastebin, then after pasting group/tab names in port properties, the new parameter would appear at the end of the group in the UI, and will only move above the group's last parameter until it's also above the group's last port in the port stack. ]]> -914 -1064 ConnectedOnly ]]> -1515 -1436 Collapsed 31,1; 31,1; -952 -1675 ConnectedOnly -205 -1403 ConnectedOnly -1495 -1273 ConnectedOnly -1761 -1276 ConnectedOnly -429 -1420 Collapsed -417 -1365 Collapsed -403 -1391 Collapsed -640 -1422 ConnectedOnly -2400 -1438 ConnectedOnly -1971 -1443 Normal -1708 -1205 Collapsed -1898 -1253 ConnectedOnly -2345 -847 ConnectedOnly -585 -1269 Normal -2099 -1482 Normal -1942 -1575 ConnectedOnly